Pure rubber - no foam

• outstanding material properties - TÜV Test REACH certified
  
• Low odor - The rubber granulate consists of 20% new industrial rubber and 80% recycled rubber
• The granulate is pressed with high density and, despite its thin thickness of 6 mm, enables above-average impact and sound protection of the floor
• Suitable for underfloor heating

Suitable for weight drops up to a maximum of 30 kg/cm2 from a height of 50 cm

• Ideal for small home gyms or commercial facilities such as hotels, sports clubs, physiotherapy practices, personal trainer facilities
  
• Can be cut with a carpet knife

Absolute hold - puzzle connection

• The corners close flush and allow the feeling of continuous and uninterrupted floor protection
• Unlike foam/man-made materials, the puzzle locking corners do not deform or warp over time due to impact or weight
• Each floor protection mat is delivered with two end pieces so that it can also be laid on angled or narrow floor areas
• Loose laying possible on all solid surfaces

Step-by-step instructions for cutting and laying the floor protection mats:

1. Safety First: Wear suitable work gloves to avoid cuts.
2. Choosing the right tool: a sharp carpet or utility knife and a guide rail.
3. The surface should be flat and level. You should also use cardboard boxes to protect the floor.
4. Measure precisely and mark the area to be cut with chalk or scratch it lightly with a knife.
5. Place the guide rail and pull the knife through the mat firmly and without putting it down. The cut should be made in one movement and the pressure applied should be even. Repeat this process until the mat is completely cut through. When cutting, spread the mat apart bit by bit to reduce friction. If necessary, moisten the knife a little with soapy water to enable it to glide better. However, note that this also increases the risk of slipping.
6. Any gaps between the mats can simply be covered with black tape to prevent dust and dirt from getting in.

Hand saws are not recommended, as it is difficult to achieve a clean cut edge. Particularly thick mats such as our UltraProtect mats can be cut to size using a circular saw with a coarse saw blade for wood. When cutting, you should just make sure that the already cut pieces are spread apart in order to neutralize the high friction coefficient of rubber.

Article ID